A P0611 on the 6.7L Cummins points to a performance problem with the fuel injection control module circuit, affecting how the injectors are driven.
What P0611 means
Fuel Injection Control Module Performance is a diagnostic trouble code the engine computer sets when the monitored value falls outside its expected range. On the 6.7L Cummins, it points to a specific area of the fuel, air, or emissions system, and reading it correctly saves you from replacing good parts.
Common causes
- Failing fuel injection control module
- Corroded or damaged module connector
- Wiring or ground faults in the injector-driver circuit
- Related power-supply problems
Symptoms you may notice
- Misfire, rough running, or stalling
- Hard starting
- Injector-circuit codes
- Intermittent symptoms with heat or vibration
How to diagnose it
Inspect the module connector and wiring for corrosion and damage, and verify grounds and power. Injector-circuit codes across multiple cylinders point at the driver circuit rather than a single injector. Confirm with a known-good module if needed.
How to fix it
Repair wiring and connector faults first, then replace the module if it has failed. Ensure clean power and grounds so the replacement is not stressed. Verify smooth operation and that the injector-circuit codes are gone after the repair.
Frequently asked questions
What is P0611?
A performance fault in the fuel injection control module circuit that drives the injectors, causing misfire and rough running.
Is it the module or wiring?
Check the connector and grounds first. Multi-cylinder injector codes point at the driver circuit; corrosion can mimic a failed module.
Can it cause a no-start?
In severe cases the injectors cannot be driven correctly, leading to hard starting or stalling.
Need the part?
We stock the parts these trucks need. Shop all 6.7L Cummins parts →